What is required in the operation process of biaxial shredder?

Biaxial shredding machine belongs to large shredding equipment, sometimes there are many matters needing attention when using the operation, at this time, we need to normalize the shredding machine operation, then today we will analyze the matters needing attention.

What are the main matters in the operation process of biaxial shredder

1, the distribution desk of the biaxial shredder should enable the operator to see the operation of each department.The distribution table of the electric mixer should be lined with rubber plate or dry wood plate, which should be tight and firm.

2, biaxial shredding machine to check the transmission organization, operating equipment, brakes, etc., to ensure normal operation, big gear ring, belt pulley and other parts, should be equipped with a protective cover.

3. The aggregate standard of the biaxial shredder should be consistent with the function of the mixer.

4, biaxial shredder to the big gear ring, runway and other wear, rolling parts add lubricating oil.

5, double axis shredder empty car operation.The operation and braking of each operating equipment shall not be allowed to operate until normal operation is acknowledged.Do not put your head or hands into the hopper and the frame to investigate or probe the feeding situation.

6. When the biaxial shredder is fed, it is not allowed to use hands or tools and other things to extend into the mixing cylinder to pick up the material and discharge the material, and it is forbidden to work or travel under it.

7. When the hopper of the biaxial shredding machine rises, the pillow of the hopper should be set at the bottom of the pit. When sorting out the pit, the hopper must be fastened with a chain.

8, the biaxial shredding machine to the mixing cylinder feeding should be carried out in the operation, adding new material must be the original concrete in the mixer all unloaded before proceeding, can not stop halfway or start the mixer when full load.