Copper cable recovery machine maintenance

1. If the screw head of the fixed blade is seriously worn, the worn screw head can be restored to the original state by replacing a new screw.Double screws and spring pads should be tightened.

2, dry copper cable recovery machine to solve the old equipment to replace the shortcomings of the tool head, the use of specially designed spindle and the tool head, the tool head is very durable, do not need to replace, just replace the blade can be the tool head.

3. When the induced draft fan is heated or makes very noise, it may be due to too much dust accumulation and blockage, so it is necessary to clean the dust collection bag.

4, in order to be able to pick up a small amount of iron in the copper rice, the new dry copper cable recovery machine is equipped with a strong magnet transmission device, can pass through the copper rice and iron dust of the iron wire grain.

5, if the broken wire particles are too large, the size of the material can be effectively controlled, as long as the gap between the accuracy of the fixed blade and the distance between the moving blade can be adjusted, the copper rice grains crushed by the miscellany wire shredder can reach 1 mm, and the uniformity can reach more than 95%.

6, specially designed dry copper rice crushing chamber, crushing waste miscellany chamber has no dead Angle, improve the working efficiency.

7, induced draft fan and dust collector, the dust collector in the stray line particles after crushing the induced draft fan air separation, discharge dust, separated from the impurity of copper rice, can be directly sold.